Reply to thread

Chest, leg armor.  I was planning on usin the logo pictured above on the left shoulder bell.... oops.  now that I look at the photo, the bells were switched. oh well.  use your imagination.


I was thinking of using the emblem pictured below on the right breastplate.  whats the best way to handle this?  stencil cut out of blue tape?  or will vinyl decals work on a convex surface?  what have the rest of you done on yours?


Cheers.





This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top