Reply to thread

Han: VaderCoke since KingJawa is no longer making them.


Side Panels: I'm 3D printing these using files from thingiverse.com produced by board member Flimsy.

These are great files! Volvo carbonate panel by crissy


Greeblies: I'll be 3D printing these as well. Also files from Flimsy.


Electronics: I ordered from Jon at Home - Fettronics Star Wars Boba Fett Mando Mandolorian Costume Custom Light Boards.


Box: Not sure yet. I'll most likely be making this myself. I wanted to grab a Zenix box, but my 3D panels won't

line up with his box cut outs.


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top