Reply to thread

Message

Well, got started on this today. I found the 13 gallon trash can at Family Dollar of all places (for $7). They didn't have the 8 gallon so I got one a little smaller for the shoulder pads. They turned out better than I thought.

Might have to go back tomorrow and get another 13 gallon one for the rest of the pieces. I got careless while cutting these out and cracked the bottom of the left chest plate, but I'll just fix it with some bondo or epoxy. Here's what I have so far...

[ATTACH=full]79108[/ATTACH]
[ATTACH=full]79109[/ATTACH]
[ATTACH=full]79110[/ATTACH]

[QUOTE="Lifeburn, post: 47350, member: 3864"] Well, got started on this today. I found the 13 gallon trash can at Family Dollar of all places (for $7). They didn't have the 8 gallon so I got one a little smaller for the shoulder pads. They turned out better than I thought. Might have to go back tomorrow and get another 13 gallon one for the rest of the pieces. I got careless while cutting these out and cracked the bottom of the left chest plate, but I'll just fix it with some bondo or epoxy. Here's what I have so far... [ATTACH=full]79108[/ATTACH] [ATTACH=full]79109[/ATTACH] [ATTACH=full]79110[/ATTACH] [/QUOTE]

This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification