Reply to thread

I have a mystery helmet, and my measurements for both teeth match his.  So, for what it's worth, here's what I measured for the width of each tooth base:


Right: 9 mm

Left: 8 mm


REMEMBER: His diagram defines "right" and "left" with the helmet facing you.  So what he indicates as "right" will be your left side if you were wearing the helmet.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top