Reply to thread

I'm looking at TK 409's measurements, and it gives the height of each tooth but not the width of each tooth at the bottom of the visor?

 

I'm layin' out my marks but I'm stuck without this....:confused


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top