Reply to thread

Hi all


i have been putting it off and putting it off, and the plain truth of the matter is i am too scared to start the silicone moulding of my scratch built bucket :facepalm


I have the silicone, the hardner, the 'thixo thingy' and the release agent.  All i need to do is cover the bucket in silicone and hope all goes well.  The thing i have never done his before and i am worried in case it all goes pear shaped.  and this is before i attempt the fibreglassing :facepalm


someone kick me :p


[ATTACH=full]5682[/ATTACH]


[ATTACH=full]5683[/ATTACH]


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top