Reply to thread

Thanks BF.  Much appreciated.  I got plugs and finished that project.  Thansk for the help with that.


Should I just buy a MR helmet?  Can I assume most of the lids are similar shapes/dimensions? 


Is it more common to see a vac formed helmet,  or a fiberglass,  or roto cast?


This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top