Reply to thread

Looking better.  I would trim up the bottom ring so that there isn't any of that return there.  That will help with being able to reshape it without putting stress on other areas.  You can use the boiling water if you want but a heat gun will work too.


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top