Reply to thread

Okay some progress has been made on ye olde practice bucket.


1. Re shaped the back 1 side needed to come out about an inch to even it up.

2. Started filling the dent and the lettering on the back of the dome

3.  Trimmed the visor out I will have to go back and touch some things up I think.

4.  Applied a primer coat Primarily to see how the dent had smoothed out.

[ATTACH=full]132812[/ATTACH]

[ATTACH=full]132813[/ATTACH]

[ATTACH=full]132814[/ATTACH]


This and the keyholes were things I was struggling with the other night.  do I need to go in and trim the back side of the visor space flush?

[ATTACH=full]132815[/ATTACH]

[ATTACH=full]132816[/ATTACH]


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top