Reply to thread

Message

Quick update for y'all. I haven't had much time to work on it this week, but I stripped almost all of the paint and picked up an airbrush and some enamel and acrylic paints to test with. By the way, a stiff brush really helps with paint stripping.

I also have some plans on the masking that should interest y'all. Stay tuned for that.

Has anybody worked with Testors model paints? I picked up a set to test because I like the durability of enamel. The spray paint I previously used was rustoleum enamel for the same reason.

If anybody has recipes for the colors using Testors paints then that would be really helpful.

Regards,
- TheLavaMelon

[QUOTE="TheLavaMelon, post: 512940, member: 14623"] Quick update for y'all. I haven't had much time to work on it this week, but I stripped almost all of the paint and picked up an airbrush and some enamel and acrylic paints to test with. By the way, a stiff brush really helps with paint stripping. I also have some plans on the masking that should interest y'all. Stay tuned for that. Has anybody worked with Testors model paints? I picked up a set to test because I like the durability of enamel. The spray paint I previously used was rustoleum enamel for the same reason. If anybody has recipes for the colors using Testors paints then that would be really helpful. Regards, - TheLavaMelon [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification