Reply to thread

Forgot to put up these pictures of the leather pouches I got from Delta 13 matches the flight suit so well.

[ATTACH=full]150462[/ATTACH]

[ATTACH=full]150463[/ATTACH]

[ATTACH=full]150464[/ATTACH]

[ATTACH=full]150465[/ATTACH]

Had a delivery today with a few more parts from Shapeways.

Grenades

[ATTACH=full]150466[/ATTACH]

Missile topper, stabilizer and beacon for Jetpack

[ATTACH=full]150467[/ATTACH]

[ATTACH=full]150468[/ATTACH]

Decided to follow Toolguys example and have pipes joining up the equipment instead of strands that came from the girth belt.

I see it as the artists not being able to put different colours in before print and makes far more sense that they are pipes instead of strands.

Toolguys belt:

[ATTACH=full]150469[/ATTACH]

[ATTACH=full]150470[/ATTACH]

Reference pictures

[ATTACH=full]150471[/ATTACH]

So I got a good friend of mine to 3D print the part to hold the connecters and also got some flexible piping to run through everything

[ATTACH=full]150472[/ATTACH]

[ATTACH=full]150473[/ATTACH]

[ATTACH=full]150474[/ATTACH]

And finally....... Pistol

[ATTACH=full]150475[/ATTACH]


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top