Reply to thread

Figured I'd share my Pepakura paper/fiberglass/bondo First Order helmet build. Enjoy :)


Paper assembling.... done! Now time for some fiberglass resin and fiberglass!


[ATTACH=full]146293[/ATTACH]


Resin and fiberglass in the interior of the helmet complete.


[ATTACH=full]146295[/ATTACH]


Rondo-ed the inside after the fiberglass and resin cured.


[ATTACH=full]146296[/ATTACH]


 Bondo and sanding time.... :devil


[ATTACH=full]146298[/ATTACH]


Sanding and shaping almost done.


[ATTACH=full]146300[/ATTACH]


Made the Lens out of plexiglass and a heat gun.


[ATTACH=full]146302[/ATTACH]


Carving out the helmet clips. Used a lot of Apoxie Sculpt to do finishing touches such as this.


[ATTACH=full]146304[/ATTACH]



Final sanding, carving and sculpting done... :D


[ATTACH=full]146306[/ATTACH]


Finally..... PAINT!


[ATTACH=full]146308[/ATTACH]



Lens shaded with spray on car lens tint.


[ATTACH=full]146311[/ATTACH]


painting done! just needs one more touch.....


[ATTACH=full]146312[/ATTACH]


Ahhh there is! Just needed a stand. :)


[ATTACH=full]146315[/ATTACH]


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top