Reply to thread

it's the box for my crossfader, the dx626.  and it's sitting on top of the shipping boxes for my babies, a pair of numark cdx's.  this is what they look like all set up.


wickedbeard - i just used masking tape.  tore it up and put a little bit here, a little bit there.  it took forever cuz i was trying to decide where to put all the little bits of damage.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top