Reply to thread

Hey everyone!


I'm in the process of painting a Hasbro DL44 for a friend of mine as a gift. I'm using pretty basic paints :


flat matte black

krylon aluminum

mix of raw umber and burnt sienna for the handle

krylon clear gloss to seal

testors dullcote to kill the gloss


Whats happening is that after I seal, the dullcote does not knock out the gloss.


I experienced the same thing on my EE3. It helped, but not completely. Compared to the flat black, it's still quite glossy.


Any tips on getting rid of the gloss? Am I using this product right? I've read it can be pretty tricky.


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top