Reply to thread

Just curious, as I'm not a Fett expert, but the top outline of the visor towards the center looks raised.  Was that intentional?

 

I'm not familiar with cold casting.  Does this mean there are metallic particles in the resin?


The scratches add a tremendous look of authenticity to it.  I'd say put more on! :-P


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top