Reply to thread

I had to fix my 96 dp one time, it was cracked all the way up the cheek to the visor:(  2 part epoxy should do the trick, but use the kind that is designed for plastic...not the standard type.  I think it is called "pastic weld system" and you can get it at walmart.  the kind designed for plastic seems to adhere very well to the vynll, be very liberal on the inside of the bucket when you apply it.  The stuff setts up very quick, but you will want to use C-clamps to hold the bucket in place while it cures.  It worked very well for me, only problem is, it sands off kinda hard, so be ready to put some hours in sanding the outside smooth again:(  Its better than a cracked bucket though;)  hope that helps:)

Damian


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top