Taking JB weld off

TeamFett

TeamFett

Well-Known Hunter
My little brother and his friend were kicking around a soccer ball in the house. Well, it flying through the air and hit my helmet, sending it crashing to the floor. The visor snapped :cry and I had to take it out, but now I have globs of JB Kwik in my helmet and they're in the way of where my new visor will go. Is there a compound or something that will dissolve the putty or should I just keep trying to pry it off with a screwdriver?
Thanks for any help,
TF
 
If you can get a dremel (or similar) in there that would make your world alot easier.. if not.. then try a rasp or file and file it down.. and if that fails... sand paper...

sorry about your situation.. that has really got to suck..
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top