Reply to thread

Thanks for the clarification on the smilies!:lol:lol::lol:


Anyway, I would use a ruler and an exacto knife, but you have to be careful and go slow while cutting it.  After you have cut it, it may be a good idea to sand away any sharp edges that may remain.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top