Reply to thread

Message

UPDATE: December 26, 2011:

Not much to show this morning. I got the first round of primer/filler sanded down, and as I suspected, there were
a few low spots that needed a little more attention. Nothing major, just around the seam on the dome, and one
small area near the forehead triangle. I slapped on some putty last night, and I'll sand it down today and shoot
one last light primer coat.

[ATTACH=full]124872[/ATTACH]

[ATTACH=full]124873[/ATTACH]

After today's round of sanding and primer, I'll give it about 48 hours to ensure it's fully cured, then I'll
be ready to spray some yummy gloss white!

[QUOTE="superjedi, post: 336585, member: 303"] [B][U]UPDATE: December 26, 2011:[/U][/B] Not much to show this morning. I got the first round of primer/filler sanded down, and as I suspected, there were a few low spots that needed a little more attention. Nothing major, just around the seam on the dome, and one small area near the forehead triangle. I slapped on some putty last night, and I'll sand it down today and shoot one last light primer coat. [ATTACH=full]124872[/ATTACH] [ATTACH=full]124873[/ATTACH] After today's round of sanding and primer, I'll give it about 48 hours to ensure it's fully cured, then I'll be ready to spray some yummy gloss white! [/QUOTE]

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification