Reply to thread

Message

Did some work on the shin tools. I used the Paterson brand found parts. Cut them down, I added a brass end piece to the chemical stirrer to help it sit better and give it some weight. I painted everything lightly and only added minor weathering to reflect the gentle paint work of the real props. I used the turned aluminum rods from Quest Designs for the anti security blade along with the cut off end of the squeegee and some visor material for the blade.

I sourced the 4th tool from the old Marco enterprises boba Fett kit as it had the right look and we haven’t found what this part actually is yet.

[QUOTE="Fettacini, post: 525409, member: 15065"] Did some work on the shin tools. I used the Paterson brand found parts. Cut them down, I added a brass end piece to the chemical stirrer to help it sit better and give it some weight. I painted everything lightly and only added minor weathering to reflect the gentle paint work of the real props. I used the turned aluminum rods from Quest Designs for the anti security blade along with the cut off end of the squeegee and some visor material for the blade. I sourced the 4th tool from the old Marco enterprises boba Fett kit as it had the right look and we haven’t found what this part actually is yet. [/QUOTE]

This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification