Reply to thread

Ok, so I have my stand in Sling Gun. It was built using Rafelfett's 3d files and a vintage Tasco telescope. It's a little rough, I am waiting to gwt my resin printer and I will redo the parts with resin printed parts( much smoother).

I also took a page out of some builder's books and kind of fudged the under barrel greeblies using airbrush parts.

Overall I'm not terribly happy with it, but it's a good stand in. I will definitely redo this.


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top