Reply to thread

I just found out something cool!


I cut a piece of the soft side of some industrial-strength velcro, and I left it in a bowl of varsol / paint thinner for about half an hour.  I took it out, and wiped the back side of it with a rag, and all the sticky stuff came off!  This will make it much easier to sew it to your vest without mucking up your needle :D


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top