Studio Scale Slave I

R

rel07

New Hunter
Hello. I'm not sure this is the right section to post this. I'm making a studio scale Slave I, using the same kit parts as the original filming model. When the master if finished I'll be making molds then casting the parts in fiberglass and resin to make a lighted model.

Here's where I am so far.

Thanks

slave_body_17.jpg


slave_body_27.jpg


slave_body_28.jpg

slave_body_29.jpg
 
CONGRATULATIONS !!!!!!

Have a couple questions..

1-How do you know what original kits did they use?

2.- Once you finish it. Will you sell the kits?


Thanks

Regards and Merry Christmas

Alfredo
 
Richard! You're here. :) Of course, I've also been following this over on RPF and the RI. Can't wait to see more!
This would display so well next to my Falcon. ;)
 
I love the size of the model! I normally don't collect studio scale models, but this has definitely caught my eye. I hope you'll also figure out a way where this can somehow be propped up and displayed without putting any structural strain on the model.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

enemyofempire
SLAVE 1 - Flight Chair
Replies
5
Views
1,912
BudaFett
BudaFett
GEEK1138
SLAVE 1, 1/6 SCALE BUILD
2 3
Replies
55
Views
20,977
Viper
Viper
M
Bondo Dust. Am I in danger?
Replies
1
Views
4,987
Mike M.
Mike M.
P
How to fill indentations in body filler
Replies
9
Views
1,703
Peej
P
bobawomble
Finding Boba Fett everywhere I look
Replies
3
Views
2,050
Juan Solo
Juan Solo
Back
Top