Reply to thread

Question the spot where the top "deck" of the jetpack meets the vertical pack of the pack is it supposed to be a sharp angle there or an eased fillet there?

I've seen pictures going either way. anyone chime in on a 501 point of view?

if it is to be eased anyone have a good idea of how to do so and keep it light?  thinking putting that much bondo will make it heavy.


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top