Reply to thread

Hi, I'm new to builds and a little confused with some of the blu prints and what goes where. The green dotted lines mean what?

When you look on the bottom overhead, it shows box like bottom with a shaped centre gap, how do you make that?

How do you make the bottom (goes to back) have the different levels? What goes between the bottom (back part) leading to the Middle circar jet. On the over head look it looks like a long sausage, if you know what I mean. The curved edges I get with waht looks like a worm (I'm asuming the panels next to the centre Tube jet). I can't find anywhere a vid showing how these templates are made into foam or PVC?Again I'm new but so eager to learn. Thanks in kind.

Any vids showing how to apply these plans would be a GOD send


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top