Reply to thread

i am having one laser cut for me at the moment (a friend so no cost to me).  He might cut me few more but i would have to talk to him about cost.


They are cut from AutoCAD templates of the original Webleys so they would be 100% accurate (although in 4mm thick alluminium).


I will keep you posted


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top