Reply to thread

If you painted it before and its tacky, that is because most enamel paint will not dry on the latex vinyl the helmet is made from, you will need to get some paint remover that is safe for vinyl and start over agian this time using a nice coat of laquer primer for auto. then regular paint should dry.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top