Reply to thread

Hi Neil, I found some 'snaps' in my local hobbycraft store, they're made by a company called 'Prym' and are called 'press fasteners' they go for a couple of quid a packet :D


They do a range of sizes, i'm not sure what everyone else uses but 10mm looked about right (please let me know somebody if this is way off as i've not attaced them yet)


Jon


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top