Reply to thread

One piece at a time, right?


Got the stock all finished up... cut it out of a really cheap piece of lumber from home depot. But some sanding, staining, polyurethane, and some Old English has done the trick. I'll post finished pics tomorrow as I'm planning to attach it then. The only issue I'm having is that it's nearly impossible to attach using the redz keys. I'm sure if it were the original 3D printed piece I would have no issue but I'm definitely struggling with getting the resin piece to glue to the wood properly (tried tonight with some JB weld but it just peeled off). I'm going to try to drill a hole down the center of the stock tomorrow along with down the middle of the part of the blaster it's attaching to and then run a metal rod down the middle.


[ATTACH=full]214400[/ATTACH][ATTACH=full]214401[/ATTACH][ATTACH=full]214402[/ATTACH][ATTACH=full]214403[/ATTACH]


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top