Reply to thread

I cut about 24 lengths of the braid and took it to my leatherworker. I think he ended up using only about 20 or 21. I fashioned a loop out of a 1 1/2 inch pvc pipe, cut in half with the radial curves angled downward and glued the thing to a piece of sintra angled just like the reference CD and took it to my leatherworker as well for the center strap with D rings. I had him chicago screw the braided belt to the JD codpiece and it's almost all done. He just needs to attach straps to the holsters. Man he's done an amazing job. I printed about fifteen reference pics from the CD for him to refer to. I can't wait to put the belts on. He says this has been a most interesting project for him. He is so used to building horse saddles and other "normal" leather products.


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top