Some advice with the screen to cover keyholes


Active Hunter
I have finished repainting the Rubies Jango I have and want to install the wiremesh on the inside of the keyholes. I am not sure how I should get this to stay. I have a 2 part epoxy for plastic and IPS weld-on #16 cement that I was told to use for my gauntlets but I do not think either of them will work for the screen. Does anyone have a recommendation?
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.