Reply to thread

Funny, the whole time i had the vest with the armor on with the magnets, i didnt have everything/anything sticking to them. you have to be an inch away for them to start to grab. But i suppose its a possibility. Also they are very strong..i was having a hard time pulling the plates off intentionally...so i doubt they would just "flip off".


JC, no i didnt do one, but it was fairly simple. i just used zap a gap with the zip kicker to attach 1/2" x1/2" by 1/8" magnets to the corners of the back of the armor. pretty much the same places i did the bolts on mine. Then i just placed the same type magnets on the back of the vest. they hold very tight but you can slide the armor to where you want it once you have all the pieces mostly in place. I personally like it. I like the fact you can adjust it, your not poking holes in the vest which works well if you ever sell the vest or change the type of armor you have.


I did however do the collar with bolts on Verbal21's cuz the back plate will apply some pull, and i didnt want it to slide up to his neck lol.


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top