Reply to thread

Thanks for the reply. A few questions dude:


Is the armor glued to the jumpsuit or you used velcro? If you used velcro, could you post some pics without the armor attached? Just to see how much cuantity of velcro did you use. (wall mart velcro?)


And how did you cut the armor pieces from the mold? Dremel maybe?


And I´m wondering, how did you made the two helmet "lines" (is that the correct word?)


thanks =-)


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top