Reply to thread

Hi fellas,


I have a Mando suit just finished...hell of a challenge I tell you. One thing annoys the hell out of me. I am only 5ft 8 and small build (except the beer processing department) The helmet I made is quite small to stay in proportion...but it is very tight and painful to get on. The Black Series is too big proportion wise to make right for my suit I think...same size as Boba right? Have any of you made the printed walls of the helmet thinner...or maybe shaved some off the cheeks inside to make it easier to get on? I had to leave the visor unfixed at the bottom to enable it to flex a bit as I put it on. I may not get it on in winter ..any suggestions?


[ATTACH=full]213103[/ATTACH]


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top