Reply to thread

Here's a chest plate I roughly cut out and started to sand down to raw aluminum [ATTACH]51034[/ATTACH] it definitely is nicer than sintra but it's a lot harder to work with... Especially while bending it I had to heat it up to about 900- 1000 degrees Fahrenheit



Sent from my iPhone


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top