Reply to thread

SingleSeat -


here is a suggestion for the wires in the clear assembly:


For the wires - use green tinted acrylic rods, when you blacken the end piece like that, the white led will make them glow inside the viewfinder, giving it more of "glowy" effect.


The ends of the rods are past the block a bit, to act like light conduits, if that makes sense.   Make sure the ends of these rods are not blacken.  (think fiber optic)


Once I get mine up and running, I will post a picture.


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top