Reply to thread

Ok, here are some of those overlooked progress shots....


Rebuilding the bottom, replacing the "tubes," and generally ripping the thing apart.  The new angled bottom (i.e. not flat anymore) is a sheet of acrylic...and a new opportunity to rebuild the vent hole in a better place.


[ATTACH=full]6986[/ATTACH]


[ATTACH=full]6987[/ATTACH]


[ATTACH=full]6988[/ATTACH]


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top