Show off your Target helmet repaint/build

image.jpg


image_1.jpg


Seeing that disney has rights, why not make a Mickey mouse themes fett. Still need to add yellow accents and killstripes. Also working on the ear caps
 
My helmet is done on the outside.
I got to put a couple more coats of clear on it, but it is done.
I detailed it with a few things, the new RF stock is made from cut down 1/8" aluminum flat stock. I have to do some work on the inside and I make a chin cup for it.

ZHXoOD0.jpg

wu4LIsa.jpg

LGJL52d.jpg

QE7Agp7.jpg

xDxyeJ6.jpg

2nFBJ9C.jpg

4pORWmW.jpg

6ik3PIy.jpg

Lynn
 
Kill stripes added. Just need to change/add a couple minor things and finish the ear caps and rangefinder

I'm also planning on making the Borden connector another hidden Mickey.

Used rustoleum spray paints and liquid latex from a Halloween store. Still trying to figure out the spraying technique before I tackle a ESB fett paint job on my scratch build.

The ears were fabricated with plastic/fiberglass/bondo. Inside was reinforced with bondo as well.

image1_1.jpg


image1_2.jpg


image1_3.jpg


image1_4.jpg
 
Last edited by a moderator:
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top