Reply to thread

Since you are probably going to be doing some sanding after you cut it out, I would invest in a good respirator. Even though it may seem like overkill, you want to avoid breathing in the glass fibers that you sand off. If you still feel like a dust mask may be enough, wet sand your helmet, keeping it wet as you sand will help reduce the amount of glass in the air ;)


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top