Reply to thread

Message

OK Thanks

IF I was to cut the stock off and drill holes, then attach an aluminum shim, then a lightweight wooden stock. Think it would break off easily?

The only reason I am hesitant to fill the stock in is because the stock is right at the handle instead of having that space from stock to handle it still wouldn't look entirely accurate, hope that makes sense.

[QUOTE="cal196, post: 40348, member: 510"] OK Thanks :) IF I was to cut the stock off and drill holes, then attach an aluminum shim, then a lightweight wooden stock. Think it would break off easily? The only reason I am hesitant to fill the stock in is because the stock is right at the handle instead of having that space from stock to handle it still wouldn't look entirely accurate, hope that makes sense. [/QUOTE]

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification