Reply to thread

Message

I hope Chris doesnt mind but I'm using his old picture of this fett-like resin kit. I have cleaned it up with bondo and green putty to get rid of all the bubbles.

[ATTACH=full]79053[/ATTACH]

Its the same exact thing, and alot cheaper than the other kits, should I modify this to rotj or leave it be. I'm not sure dremeling the stock off would be a structuraly good idea.

Has anyone done this? Would anyone even motice that much

[QUOTE="cal196, post: 40344, member: 510"] I hope Chris doesnt mind but I'm using his old picture of this fett-like resin kit. I have cleaned it up with bondo and green putty to get rid of all the bubbles. [ATTACH=full]79053[/ATTACH] Its the same exact thing, and alot cheaper than the other kits, should I modify this to rotj or leave it be. I'm not sure dremeling the stock off would be a structuraly good idea. Has anyone done this? Would anyone even motice that much [/QUOTE]

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification