Reply to thread

Message

Actually I made my own boots, Its kinda funny because I made them from some suade and an old tire. The tire was difficult to sew onto the boot because the steel belting inside the tire ripped the thread, But I managed to cercumvent the problem. To make my spikes I bought a very large screw with a hex head and a very long unthreaded collar. I cut the hex head of then ground the collar to a point. I then stuck it into a drill and and filed it while it was turning until it was the shape of the spike. The threaded portion I was able to just screw into the front of the boot.

[QUOTE="Migrate from As You Wish, post: 1374"] Actually I made my own boots, Its kinda funny because I made them from some suade and an old tire. The tire was difficult to sew onto the boot because the steel belting inside the tire ripped the thread, But I managed to cercumvent the problem. To make my spikes I bought a very large screw with a hex head and a very long unthreaded collar. I cut the hex head of then ground the collar to a point. I then stuck it into a drill and and filed it while it was turning until it was the shape of the spike. The threaded portion I was able to just screw into the front of the boot. [/QUOTE]

This thread is more than 23 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification