Shin Wrap Folds

Baylez

New Hunter
Hi, this is my first thread on here and I was just wondering about Din's left shin wrap, I've seen a few people 3d print a base layer with screen accurate folds and glue the leather over top, given my lack of proficiency in 3d software I was wondering if anyone has a file for this. Any help or advice is appreciated.
Thanks.
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top