Reply to thread

I know the preferred helmets are not Rubies but it is what I can afford right now. I saw a previous posting about shaping it with hot water. Are we talking like steaming hot water (Boiling)or just very hot water from the tap. I would like to cut out the visor but have not ever done this before. What is the best way to cut the plastic since the visor is not really a full visor?

Thanks in advance!


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top