Reply to thread

I had seen pictures of the Mini Bust, obviously but not the blurb that goes with it. Interesting to say the least. It is possibly a spoiler as I haven't seen anything on the official site or in the novel.... But yeah she is a vital character in the game :) Unless GG have jumped the gun...

Shae Vizla Mini Bust

Spoilers in there if they are true...



[ATTACH=full]117608[/ATTACH] [ATTACH=full]117609[/ATTACH]

So, score one for inorganic collection! PVC pipe galore and all free! Most from one house too. Must have had a total plumbing refit.

So the greaves in the artwork are pretty flat, I decided to cut and shape from the pvc pipe. Sigh. Not as easy as it might have been due to a few issues. So I am going to have to make a solid base and then use these pieces over that. Luckily they soften nicely with a heat gun. It's trying to shape them that is not working out.I need to tape as I go which doesn't relaly happen to work well on real legs...

Now I should wind up with something closer to the maquette style which is not quite as complex as the cinematic but has nice dimensionality.



[ATTACH=full]117610[/ATTACH] [ATTACH=full]117611[/ATTACH] [ATTACH=full]117612[/ATTACH] [ATTACH=full]117613[/ATTACH] [ATTACH=full]117614[/ATTACH]

So here I ma putting plasticine all over the legs of my mannequin. She is alien. Her legs are really skinny front on but in profile really wide. What you don't see here is my final shape which has the clay scraped right back from the front and back and a little more from the sides taken out. I think I took off a good 800gm shaving with a ruler.


[ATTACH=full]117615[/ATTACH] [ATTACH=full]117616[/ATTACH]

And tonight I got cloth over those legs and in the back of the chest armour.


[ATTACH=full]117617[/ATTACH] [ATTACH=full]117618[/ATTACH] [ATTACH=full]117619[/ATTACH] [ATTACH=full]117620[/ATTACH] [ATTACH=full]117621[/ATTACH] [ATTACH=full]117622[/ATTACH]


As expected the card buckled a bit. No biggie as it really only buckled where the next layer goes over. This is more card and corrugated card all soaked in more resin and stuck in place. Cellotape is holding it in place while the curing takes place. Inelegant but it works. It should be sturdy enough once the final layer of cloth and tissue go over and be fairly light as the corrugated card is only soaked not filled with the resin.


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top