Reply to thread

Arnold, initially, I wasn't going to 'glass the inside.  But once I made the decision to install a servo system, I went for the fiberglass to add stability.  So to answer your questions, yes, I think that 'glassing it prior to cutting the visor would be a better idea.   :)




Rippy is the unofficial fifth member.  To make it official, he has to relocate!


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top