Reply to thread

Message

I use a combination of both. My armor typically is almost entirely scratch-away while my helmet is often topically applied in abundance and reverse scratched away to reveal what would technically be the 'top' layer.

For instance I paint the visor area red. I then apply silver, then dark grey, etc and not necessarily in that order. I then scratch away at the grey and silver to reveal the red underneath. Works great.

Here's a pic:

Hope this helps,

Phil

[QUOTE="jrnymanprotector, post: 19099, member: 78"] I use a combination of both. My armor typically is almost entirely scratch-away while my helmet is often topically applied in abundance and reverse scratched away to reveal what would technically be the 'top' layer. For instance I paint the visor area red. I then apply silver, then dark grey, etc and not necessarily in that order. I then scratch away at the grey and silver to reveal the red underneath. Works great. Here's a pic: [img]http://www.ezshots.com/members/mereel/images/mereel-351.jpg[/img] Hope this helps, Phil [/QUOTE]

This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification