Reply to thread

Working on price. Right now the prototype is a bit bigger than we had hoped. The printed circuit board will shrink the base a bit. We are putting in a 10 position pot to make the version of chest display selectable. Should work out well.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top