Reply to thread

Message

:confusedI was wondering if i was the only person to notice what looks like a dent that was filled in slightly up and to the left of the one showing on my 2002 rubies, i know it's crap but its all i can afford right now. Also I was wondering what side of the helmet the DP license was on, because on the back of the helmet (on the oposite side of the trade mark) is what looks to be a filled/covered copywrite.
:confusedI was thinking about moving the dent to where it once was, what type of bondo or filler would work best for the non fiberglass helmet.?
:rolleyesI'm i correct in thinking that the mold was a reused Don Post?

[QUOTE="Maximillian, post: 78545, member: 1252"] :confusedI was wondering if i was the only person to notice what looks like a dent that was filled in slightly up and to the left of the one showing on my 2002 rubies, i know it's crap but its all i can afford right now. Also I was wondering what side of the helmet the DP license was on, because on the back of the helmet (on the oposite side of the trade mark) is what looks to be a filled/covered copywrite. :confusedI was thinking about moving the dent to where it once was, what type of bondo or filler would work best for the non fiberglass helmet.? :rolleyesI'm i correct in thinking that the mold was a reused Don Post? [/QUOTE]

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification