Reply to thread

Message: <blockquote data-quote="TK Fett" data-source="post: 4750" data-attributes="member: 195">I have LEDs in my Boba rangefinder and all you have to do is supply a powers source but not to strong because to much power will burn them up in seconds. The LEDs I used were about 2.0 volts a piece. I used 4 so that equaled 8 volts and a 9 volt battery wasnt to strong. Then I bored out my DP range finder (a hollow one will work best), poped the top off of the R/F then ran the wires all the way through stalk. Then simply hook up a switch button (not a momentary) and a battery. There you go. If anyone needs more info feel free to PM me. P.S. these leds DON'T blink.</blockquote>

This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification